Search results

  1. I

    Mercruiser B4S Conversion

    Hey all, We have a 2007 Four Winns 260H that we love and is in great condition. We also have surfed a coupke of times and love it! With the release of the forward facing Bravo 4 how easy would a swap for our Bravo 3 be? Anybody know if they use the same transom assy?
  2. I

    2003 Four Winns 260H Port Dash Shroud Removal

    Hey all, the port dash shroud on our 2003 260 Horizon is cracked between the two “glove” boxes. I am going to take it off to repair it but I am not sure how it comes off. I know there are rwo bolts behind the upper glove box but not sure of anything lower. It looks like there is a removeable...
  3. I

    350 Mag MPI Questions

    All, I have a 2002 Four Winns Horizon with a 350 Mag MPI (OM254958) and a Bravo 3 drive. The past couple of times we have been out the engine has been hard to start after its been running. So I did some searching on possible causes to see if I could check a couple items and noticed that some...
  4. I

    2002 Four Winns 240H Floor Support

    All, We have just purchased 2002 Four Winns 240H and I have a question about the support structure under the bow section flooring. When you step on the floor in the center of the bow section there is about a 1/2" of flex in the floor. I have checked the deck on either side in the storage...
  5. I

    Mercruiser 5.7 Momentary Engine Cutout

    I have a 1995 Crownline 225BR with a carbureted 350 Mag engine, Thunderbolt V ignition with knock sensor, and an Alpha 1 Gen II drive. I have an occasional situation where the engine will act like the key has been shut off for a split second and then immediately return to running fine. This...
  6. I

    Starter or timing issue???

    Here is the background....Bought a 94 Crownline 225br with a rusted up engine due to the plug being left in it, serial #OF354207. Rebuilt the engine, new fuel pump, and rebuilt the carb. Finally got it started after getting the distributor lined up correctly. Brought it up to temp, oil...
  7. I

    Upholstery help

    I've been lurking here for awhile trying to soak up as much knowledge as possible for my upcoming interior work. I have seen lots of examples of seats with piping but few without. Below are some pics of the sunpad and rear seat back for my 1994 225BR Crownline that I need to redo. I have a...
Top