FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Re: 70hp Evinrude (1976) Power Tilt/Trim - How to get fluid in?
Thank you for the advice but whenever I loosen/take fill screw out fluids keeps running out as if it is already full. But please see pic to see how much fluid was lost on the ground when the manual release screw was not fully...
I have what I think is a 1976 70hp Evinrude (Model 70673D - Serial A312733?) & don't know where/how to put in fluid to fill up the power trim. I was told that the correct spot to fill it may be the screw on starboard side of cylinder about an inch & a half from the bottom?
But when I start to...
I have what I think is a 1976 70hp Evinrude (Model 70673D - Serial A312733?) & don't know where/how to put in fluid to fill up power trim to replenish after leaving manual release screw loose & loosing a lot of fluid.
I have never had to put fluid in & don't think I even have the correct spot...
