The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
Can I use an Alpha 1 Gen 1 pump on an Alpha 1 Gen 2 set up?
Tried the search bar with no luck.
I know the harness plug is the exact same, so wiring wont be an issue.
Thanks,
Sean
Please let me know which pieces go where based on these two pix.
I am assuming washer just below bolt head, then top of bell housing, then spacer on the bottom of bell housing- then nut thats not in pic?
Thanks,
Sean
So I'm getting very close to putting the new engine in the boat and was hoping I could get some help with a few wires I"m no 100% certain on. The first...
Like the caption says, white/red and white/blue off of ignition module and black. Where do these go? Are they only used for diagnostics...
Previous post's would let you know I bought boat (1997 Merc4.3 and Alpha 1 Gen 2) with a cracked block.
I got the old engine out and the new engine on Saturday. While the outdrive was off I saw I need a new yoke, joints, gimball bearing, 3 bellows, shift shaft seals, carrier assembly, anodes...
After posting several threads on this boat I bought that had a pushed out casting plug, hours and hours of labor, and B.O.A.T. (breaking out another thousand) I've got these 3 pictures to share and a request.
Please let me know what if I can get this block repaired (if so is it a reasonable...
Okay, so I've put out a few threads about the boat I bought, and on Saturday I had a pretty darn good confirmation my worst fears are true. The block is I'm 99% sure cracked. Will pull the engine this weekend, pull intake and heads to check the gaskets to be 100%.
Anyway, can someone please...
So I bought a boat back in January that came from Jew Jersey. When I got it back to NC I saw that one of the casting plugs was pushed out (guy hadn't drained the block). It ran for an hour in a tub of H20 and for 20 min with the muffs/garden hose on, with no H20 in the oil that I could see...
Okay, so I've been working on this 1997 Stingray since January when I bought it. I thought I finally had everything ready so we could take our maiden voyage this weekend, but yesterday after I shut off the engine I noticed some black oil coming from two small holes in the outdrive.
The outdrive...
Situation. The boat was sitting this winter in New Jersey and the person who owned it previously didn't drain the water from the block. I got the boat back to NC and let it thaw out inside.
One casting plug was pushed out. I did a ghetto leak test by pressurizing the cooling system to 45 PSI...
Can someone please tell me if GLM or HGE makes a better manifold/elbow kit?
I am planning on buying these and then just figuring out how to get the exhaust and water to the Y pipe making stuff/adapters myself I think.
I also am trying to order new exhaust/water shutters. Can someone please...
So this will be my first outdrive water pump replacement. The only other one I've done is on a 1969 Evinrude 115 with electric shift- so please excuse my ignorance :p
So the question is, are there really no cables going to the bottom of the outdrive? I can really just put the thing in...
Okay, so I am new to this forum and was hoping some of you seasoned experts could help.
I am thinking about buying a 1997 StingRay 190 with a mercruiser 4.3. As far as I know the boat runs like a champ and has been owned by two of my brothers friends since new.
Is there anything I should be...