Search results

  1. P

    V-6 200hp Blackmax Timing set-up

    :)OK...the plot thickens.... I managed to screw around with a few erratic timing settings and the motor now idles fairly reliably... I has lots of "snap" when I crank the carb linkage and the excess oil in the exhaust has settled down to a reasonable amount. I am not going to rev this thing too...
  2. P

    Excess carbon-heavy oil from V-6 200

    Just ran up my rebuilt V-6 2.4. 1986 V-6 200hp Blackmax, Oil Injection removed. SN: 06592288 Seems to be waaaaay too much oil residue from the exhaust and in the cylinders...The residue is a nasty thin oil that has a heavy aroma of carbon/burnt fuel. The common cause for this escapes me. Timing...
  3. P

    Need a 2.4 V6-200 Flywheel....Ack!

    During the tear-down of my old 200 in the fall, I needed to "slightly" heat the flywheel hub to remove it (having snapped a Merc puller and stripped another) and I knew that I would end up killing the magnet ring located under the flywheel hub....not the magnet ring INSIDE the flywheel...the one...
  4. P

    Clear Hoses for Fuel and Water?

    Hey All: Just a quick question regarding my plans to finish a V-6 Merc rebuild. Have any of you tried Clear Hose for your main Fuel Lines and Water Lines? I am trying to think of a reason why I have not seen this done on other motors I have either owned or seen. The fuel pressure is not an...
  5. P

    Merc V6 Bleed Hose Routing and types.

    Hi Everyone! I am in the final stages of a complete rebuild on a V6 2.4 1986 V200 (200hp) and I cannot positively identify the correct placement of all the bleed lines on this motor. The Clymer Manual I have is not good enough as it has only a partial layout of one side of the routing pattern...
  6. P

    200HP V-6 Merc Crank Hub search

    Hey HI alll: I am overhauling my '84 2.4litre and I needed to heat the hub on the "top" end of the crank in order to get it off.... Needless to say, I was not too worried about destroying the trigger assembly under it. (as I was going to replace it anyway)....but stupid me, I forgot that there...
  7. P

    Kayot Identification required

    Hello All: I am anxious to find out the Model and hopefully the year of this Kayot... I do not know of any open-hulled Kayots since the early 70s...but it appears original (unless the deckboat upper was cut out professionally) If anyone knows what this is..and how old it is, I would greatly...
  8. P

    Kayot Identification

    See my other post in the Restoration Forum..Thanks
Top