Search results

  1. K

    yamaha 115 totally stumped

    i have a 1987 yamaha 115 2 stroke outboard. Main problem was that when it was at full throttle it would go for about 30 seconds then bog out like its not getting enough gas. i thought i could figure it out myself and have worked all summer on it. Here is what i have done so far...compression...
  2. K

    transducer mounting,marine tex?

    hi, i have an 18ft aluminum boat and need to take off my old transducer and install a new one. my question is what do i fill the old holes with and what do i do when screwing in new one to ensure water tight?? ive heard alot about marine tex. is this an epoxy putty and is it easily available? i...
  3. K

    plywood thickness?? need advise

    hi, i have a 1988 starcraft 18 ft. aluminum deep v. i have taken the old 1/2 inch floor out and replaced it with 5/8 inch thick plywood. will this cause me any problems besides a little more weight. i just felt like the 1/2 inch wasnt sturdy enough. thanks.
  4. K

    need help with foam problem

    hi i have a 1988 starcraft 18ft aluminum v bottom. i am replacing the floor and found foam was a little wet. it is only wet on the bottom but is still a little heavy. just wondering if there is an alternative to expanding foam since it is so expensive, like maybe styrofoam board with moisture...
  5. K

    topside fuel box venting

    i have an 18 ft starcraft with major tank problems. i didnt want to deal with the gas tank being under the floor where i cant access it so im putting in a topside tank. i want to put it in the rear of the boat. iwant to biuld a box to enclost the tank in and put some seats on either side. how do...
  6. K

    1987 Yamaha 115 not getting fuel

    i have an 87 yamaha 115 etlh 2 stroke..idles great but has an obvious fuel starvation problem..when i give it throttle it'll go for a couple minutes then bog out. if the bulb is pumped while running it will run great and get to full throttle then the bulb goes flat and again bogs out. Spark...
Top