Search results

  1. T

    No electrical power on starboard side of boat

    Pulled my 1989 Sea Ray 30Ft Weekender into my well And plugged the power cord in. Apprx, 4 days, I went back to the boat and tried to start it, and the whole starboard side is totally dead. I tried to trouble shoot a little (battery cables, Made sure the toggle switch above the key was on, )...
  2. T

    Plumbing issues, parts needed

    I have a 2006 Searay 270 Amberjack. One of the spigots on the bathroom sink is leaking. After calling several searay dealers, I was advised that the faucet is discontinued, and I would probably have to buy the whole assembly ($260.00) One of the dealers did tell me that there is someplace on...
  3. T

    RAW WATER IMPELLER REPLACE (MERC 496cu.in. 375 hp. B-III enclosed cooling system

    Does anyone know of someone or somewhere that I might find information on replacing the raw water impeller on enclosed cooling system on a 396cu.in. 375hp B-III? Thanks Ray
  4. T

    Impeller replace merc bravo III 496cu.in.375hp. ENCLOSED COOLING SYSTEM

    Does anyone out there have any info or video on how to change a water pump on a 496cu.in bravo III with an enclosed cooling system? I sure could use any instructions. with the enclosed cooling system, you cant even see the pump. Thanks Ray edit;
  5. T

    MANUAL for mercruiser 496 cu in 375hp

    A while back, someone showed me how to download the manual for a 2006 mercruiser 496 cu in 375 hp engine. I need to change the inclosed cooling systen fluid this year, and when I went into my documents, it was gone. Can someone show me how to get into the manuals or maybe walk me through the...
  6. T

    Impeller replace on 2006 mercruiser 496 ci in, 375hp

    This motor has the water separator filter next to the water pump. And it also has an enclosed cooling system. Can anyone walk me through the steps for replacing. the impeller? (bravoIII with enclosed cooling system) Thanks Ray
  7. T

    YAMAHA (Two stroke, 115HP) Bogging Issue

    Every once in a while, when I attempt to accelerate from an idle, the motor will bog and stall out. If can choke it before it stalls, It will than accelerate. Any suggestions?
  8. T

    2001 SAILFISH MDL 186 (center console)

    There are two drain holes located in the cockpit, at the rear of my boat. If I step to the rear of the boat, lake water enters through these holes. Then if I move to the front of the boat, the water will not drain out. Eventually, the water will seep out into the bilge through the battery...
  9. T

    yamaha manual

    I just bought a 2001 fishing boat with a 2001 115 HP yamaha 2-stroke. The manual wasn't with the boat. Can anyone tell me where I might be able to download a service manual for this motor. Also, where would I find the Serial number on this motor? Thanks Ray Gibraltar Mi.
  10. T

    FUEL FILTER REPLACE 496ci.in 375hp (2006)

    Can anyone tell me how much trouble ill have in replacing the new type fuel filter. Can someone possibly walk me through it? Ray Gibraltar, Mi.
  11. T

    2006 Merc 496cu.in. 375hp (WINTERIZING)

    Could anyone out there assist me in winterizing an enclosed cooling system 496 ci.in. 375hp? I dont know what the blue hand pump is used for thats clipped on the motor. For all intents and purposes, could I connect a hose to the outdrive and run anit-freeze through it, and not worrying...
  12. T

    3.0 I/O Blown Head Gasket

    While Replacing a blown head gasket, I noticed a pitting between #2 & 3 Cyl. Its not very deep. I could lay a piece of dental floss in it. The head is in good shape. I cant throw any more money into this money pit. Has anyone used this high temp repair compound from permatex? Or maybe another...
  13. T

    mercruiser 3.0 engine (Blown Head gasket)

    I had 20PSI in #2 Cyl. Thinking thaqt it was a burnt valve, I removed the head, found that the head gasket was blown between #2&3 Cylinders. I also discovered that there is a hair line crack between these cylinders. Its not much deeper than a piece of dental floss. Its an old boat and I cant...
  14. T

    1986 evanrude 15Hp. impeller replacement

    Can anyone walk me through removing lower unit and replacing impeller? Thanks.Ray
  15. T

    Evinrude 15 hp 1986 water pump

    IMPELLER REPLACE HELP. I have a 15HP 1986 evanrude motor thats been in storage for about 12 Yrs. I'll be pulling it out of mothballs this summer and i'd like to replace the impeller. Would one of you fella's be so kind as to walk me thru the steps? I'm not sure about the shift rail, hidden...
  16. T

    Evinrude impeller replace 1985 15hp

    CAN ANYONE TELL ME HOW I GO ABOUT CHANGING THE IMPELLER IN MY OLD 1985 EVINRUDE 15HP. Ei. should the motor be in neutral when removing lower unit? or do anything with the shifter rod? Thanks Ray
  17. T

    Impeller replace 1985 evinrude 15hp

    Iv tackled alpha outdrives before but never changed an impeller in this little old 15hp evinrude. Is there anything that I need to watch for ie: what geer should I be in. or do i have to watch the shift bar so that it doesnt move? or maybe anything else that could be different? Thanks Ray.
  18. T

    oil blow by on mercruiser 470

    motor runs great, but at higher RPM's, it shoots raw oil out of air cleaner hose
Top