The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
Here is the back of the tach. I want to verify the pinout so that I make sure it is hooked up correctly so that I don't burn anything up. The left pin is showing the ground symbol. The middle or say between the left and right pin you can see it says 12V and the far right pin is labeled 59...
I have a friend that brought his late 90 model wave runners over for me to store for the winter. Last year he put new batteries in them. I noticed when he dropped them off the keys where stuck in the ignition switch. Would this cause the ignition box to be fired on all the time and kill the...
Carb has been rebuilt. When I purchased the ski I was told it was hard cold starts without starting fluid and had to run the ski at half choke to run. I took the ski out for a test run and found that it was pretty much true except I got it to start after a bit without the start fluid since its...
Merc ID 6952167
I was lucky enough to come across a friend that needed to move a boat and I aquired it. It's a 1985 Kingfisher with this motor on it. In 2002 the owner got stuck on a sand bar and over done it trying to get off of it and damage the transom. It's been parked since. So thats 7...
I'm looking for the correct carb kit for my carb. Its a 1988 Searay 19' Cuddy cabin with merc 4.3L 175 2BL seems to be the Merch carb. Right below the fuel in line theres the numbers 33049565 7601. I asume its the carb number. When looking for the parts the vendor dosent seem to be able to...
It a 1988 19' Sea Ray Cuddy Cabin with a 4.3L Merc. Alpha 1. The Throttle/Shift Handle stays loose. Its a Quick Silver. I use an allen wrench to tighten it and its fine. It dosent take much to make this thing loosen up again. Any suggestions or maybe I can use lock tite or do I have...
Begining of this boating season I replaced the plugs, and wires on this engine due to it missing and sputtering a bit from time to time. It didn't matter if the engine was cold or warm you just bumped the key and it would fire right up and you could take off no problems. It seemed as it was...
I had just rebuilt the OMC upper gearcase since it had locked up due to improper greasing of the housing. This is a boat I help fix with my father. Of course it has been greased properly this time. After it was greased before, it ran for about five minutes and the upper gearcase bearing...
What is the proper method to set the timing on 1988 Merc V6 262 4.3L engine? Just reset the distributor and I know the timing degree I just need to know the correct method? Doesn't it have to be in base mode? If so how do you do this?
Hey folks as the title says 1986 5.7 GM OMC Upper Gear box is frozen. I assume we didnt refill the lower unit properly and caused it to freeze up on the lake. We where going across the lake and it stopped suddenly. Couldn't been 10 mins. I have found after pulling the terndrive off, the...
I was woken this afternoon to help get my dad out of the lake since he took it out for the first time since the winter. He was going across the lake and suddenly his motor mad a bump sound and is locked up. Has an 1985 Searay with a GM 350 in it. I made it about half the distance as he did when...