Search results

  1. P

    Losing Power after couple hours on water - 1964 Johnson Outboard

    1964 Johnson 60 Horse Outboard. A lot of new parts, but hoping to receive some ideas on the next troubleshooting steps: The engine fires up quite easily, runs well. After getting out of the water, all plugs are burning clean; no carbon buildup. Boat planes out well, gets to top speed. Once the...
  2. P

    One Spark Plug Burns too cleanly - 1964 Johnson Outboard

    The symptoms make me feel like fuel is not getting into the cylinder. However... I have a 1964 Johnson 60 horse. I replaced ignition last year, all new plugs this year, new reeds, new gaskets, carb rebuild, etc. It seems to be running pretty well. Idles great, sounds great on throttle (haven't...
  3. P

    1964 60 Horse Compression in PSI?

    I did a compression test on my '64 Johnson VX-10S 4 Cyl 60 Horse. I had a consistent 60 PSI across all four cylinders. My question is, is this an acceptable amount of compression for this engine? Consistency is a good thing, but this motor is so old, is it possible that they're all consistently...
  4. P

    New primer bulb causes engine to run better...and worse

    I am using a Johnson fuel line/bulb. While in the water, I can't do anything more than plow, though I did get on plane once or twice for a short period before slowly losing power. I purchased the cheap $20 bulb from Wal-Mart. Now the engine runs pretty well, and gets on plane. The catch: once it...
  5. P

    Generator for 1964 Johnson Evinrude 60 horse VX-10s V4

    I am attempting to nail down a means to install a generator for this engine. It seems that I've found an appropriate generator, and voltage regulator. The difficulty is connecting to the crankshaft of the engine. With this engine, there is one pulley that drives the magneto/distributor. Can I...
Top