Search results

Motor bogs and has to be choked when first getting up to plane. Once boat is up and planing will stay there till it is backed off to lower speed. How do I check to see if problem is leaking intake gasket.

1992 Evinrude 115 HP. is hard starting. I have to choke it every time I try to get it up to top speed. Once engine is at top speed will run with out choking until I slow down. Then to get it up to top speed I have to choke it again. Motor has good jump spark. Good compression on all cyl. I have...

1992 Evinrude outboard motor is hard to start when in the lake. To get boat up and planing you have to keep pushing the key choke. When boat is uo and planing will run at that speed untill you pull back on the throttle.

My evinrude 115 HP runs okay after starting and driving to fishing spot. After I jig for A while and move motor runs terrible bogs smokes . I have replaced power pack tested coils did carbs . Reset shift cables. Any ideas what I should test next. Thanks Dale

My 1992 evinrude seems to run great going to 1 st stop for fishing. after that it will bog some times when you try to take off and get boat up and planeing.. It sometimes kills the motor when you push gas shifter lever. I seems prop sometimes seems to race but not catching enough water

115 HP Evinrude 1992 is wet on primer prime run lever. seems to leak a little as it is wet at top of prime run valve. You can see it weep when you turn it. Would this effect motor at starting

Can I time 1992 Evinrude 115 HP with muffs or does it have to have test tank.

1992 115 hp evinrude outboard motor has no spark on the #2 Cyl. it is very hard to start . Will 1 cyl. make A outboard that hard to start

My 1992 evinrude 115 hp will not start. The motor has compression of 127 and 128 and 126 and 128. I have done carb kit. replaced plugs. Plugs are wet after I try and start . Motor will fire if I hit primer when turning over. If it starts it takes A long time with lots of priming . There is spark...

I have A Evinrude 115 HP 1992 model. Replaced seals and O ring now cant install the 4 bolts. I can thead in line up rods but I can not get bolts started in same hole or in the opposite hole. What could cause this

My 1976 85 HP Evinrude will not start After I pull Grand kids on tube. If I let it sit for awhile it starts with out problems. Is there A switch oh engine that prevents engine from starting when hot. I installed new impeller 2 years ago . The only time it will not start is right after I pull...