Search results

  1. S

    1991 60 deg 175 main bearing & race info

    I want to replace the three split races and bearings and am having a little trouble figuring out what the part # for the races alone are. I have a few retainer and rollers new in the box(387041). It looks like you can buy the races, ring, and rollers and retainer as one(335825) but I don't need...
  2. S

    1991 60deg 175 recirculation check valve

    1991 60deg 175 recirculation check valve replacement I have one that I want to replace that has a hole in the seal and it leaks. The 1991 schematic isn't to great with id'ing the check valves, and it looks like they say only 3 are required. It looks like the part # is 394884, they say 3 are...
  3. S

    Looking for some insight and input on a 1991 175

    Hello, I have been wanting to put a 90's smallblock v6 looper in place of a 89 v6 crossflow. I have a friend who has had a 200hr 91 175 that has been sitting for years. I believe my harness will plug right in?? I realize the first couple years of the 150,175 60deg. motors can develop a crack...
  4. S

    Ohm Range for T/T Sender on 89 V6 Crossflow

    Curious what the ohm range is going from up to down. Thanks
  5. S

    150 Crossflow Exhaust Cover Water Leak

    A couple months ago I noticed small leak around a couple of the starboard exhaust cover bolts. It drips about 2 drops every 3 seconds idling at the dock, and drips about every second on muffs. The leak hasn't gotten any worse. Should I assume on doing just the outer gasket? Do I need to do...
  6. S

    79 V6 Crank into 89 150 Crossflow

    I have an almost perfect 1979 200 Crank, bearings and ends. My 89' 150 Crossflow's crank splines are completely gone. I know that they say there is a a 76-85 (388306) and 86-91 (396256) but I seem to remember if you have both outside bearings the old crank can be used in the later motors and...
  7. S

    150 Crossflow Miss, Reduced Power, Speed, Tach High

    I had a recent multiple failure apparently. *I lost the gears in the lower of my 89 150 Crossflow at the same time that I stripped the driveshaft splines. *I pulled back the throttle before it shot way up and turned the motor off right away to not overheat. Fortunately the crank splines looked...
  8. S

    Smoky Crossflow Telltale

    Hello All, Here's some info before my question. The other day I was running my 1989 150 Crossflow and dropped the gears in my lower at about 4000 rpm. I caught the throttle before it shot to the moon and shut it down within a few seconds. It did go well above the normal temp by the guage but...
  9. S

    New Guy with some ?'s on a Base Gasket Leak 150 x-flow

    Hello folks, I have recently bought a old project boat that came with a 1989 150 Crossflow. I have put about a hundred hours on the motor since bringing it back up to snuff with a carb rebuild, l/u reseal, water pump, head gaskets, diverters, stats & poppets. The motor holds between 100 & 105...
Top