FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Does anyone know if I could wire an in dash tach for a 1992 15HP evinrude? I do have a charging system on it but it's pull start.
I heard that you may be able to connect to the yellow wire on the stator?
thanks for any input.
BB>
1992 9.9hp evinrude.
Looking for set up and fine tuning the carb cam follower and how to determine proper
spark advance. bascially any set up and adjustments that may be needed from a carb
replacement. I would like to go over any adjustments that may be needed to make sure
everything is...
Ok.. heres the details on whats going on with the engine.
1992 15HP long shaft owned since 1994 and has low hours
sat for 4 years and just before storage in 2008 would bog down after engine got hot (may not be related) wasn't too bad but it would definitely loose some HP. replaced the coils...
starts and runs very good but after running full throddle for a while it will start to loose power. example... if I run full throddle with a cool engine the boat will go about 12mph but then slow to about 8-9mph as it warms up. Usually takes about 5 minutes of open throddle to start slowing...
I have a '57 evinrude 3hp and looking for some advice on how to repair the shaft on this motor. The shaft stripped where it meets the crank. When I pull the lower unit off the shaft that drives the prop is stripped where it connects to the bottom of the engine. The shaft itself looks ok so it...
