Search results

  1. earnies2

    Urethane pant

    I have a 1999 hurricane deck boat the sids above the rub rail and the back and engine cover are badly oxidized i've tried wet sanding ,buffing and waxing it's still dull,is it possible to spray new gelcoat or can i paint it with automotive urethane automotive paint,if i can paint it is thier any...
  2. earnies2

    Skeg repair advice

    I have been looking to repair my skeg it's on a 99 bravo 1 with a 7.4 merc.i have been surfing the net and found several products 1,skeg gaurd 2,skeg pro 3.black fin or 4,river runner.....any oppinions on theise products ? the only thing i noted is the skeg pro would not be big enough to cover...
  3. earnies2

    1999 7.4 MPI Exhaust manifolds

    the boat has 160 hrs on it the manifolds are original the boat has never been in salt water only fresh water. how do you tell whan it is time to change the manifolds? is their some signs to look for or test to do to check the manifolds. and if i do replace them should i usr cast iron or alumium?8)
  4. earnies2

    1999 Hurricane FD248 ?

    I am looking for a deck boat and i found this one it has a 7.4 merc with a bravo outdrive the boat looks new with 158 hours on it with a load rite tandem trailer thay want 24K for the boat whats your thoughts????
  5. earnies2

    carb ?/advise

    i have a 91 renken bowrider w/a 4.3 omc cobra and a 2 barel holley, my carb is junk the throttle shaft is wiped and the fuel boal is striped wkare the needle and seat goes.... i was wondering if i could put a 600 cfm holley on with a adpter or replace the present carb with a rochester 2 barel...
  6. earnies2

    OMC Iginition interupter switch

    has any one replaced thies switchs with after market or generic ones if so what part #s did you use? I plan on replacing mine and before i do all the recherch maby somwon already has the info THANKS
  7. earnies2

    Trailer problem

    I usually launch in deep water and have no problem pulling my boat out. the other day i launched in shalow water and had a hek of a time getting the boat on the trailer usually i float it on (no prob) i was able to get the boat 1/2 way on than I winched it the rest of the way on it was so hard I...
  8. earnies2

    OMC u/joint-gimball help

    I removed outdrive becaus of u/joint - gimbal bering noise gimbal bearing came out with out drive does that mean the housing that holds the bering is no good it is not corroded the bering was stuck to the shaft the shaft looks ok .the seal behind the bering its spring came out ,i am having a...
Top