Search results

  1. Bosunsmate

    Evinrude 1980 35hp Torque spec Flywheel

    Hi, Im wondering what the torque spec is for the flywheel nut. 27mm nut? Thanks
  2. Bosunsmate

    Mercury 7.5 1973 Blowback, ok reeds

    Hi, Im trying to repair a Merc 7.5 hp serial 8004212. It had weak spark so i replaced the insulators and wires and spark came good. It still wouldnt start so i put fuel in the spark holes and it went great for a second or so. i noticed that it had some blow back into the carbs. I was not...
  3. Bosunsmate

    Suzuki 85hp 1982 removing crankshaft

    Hi Someone put glunky oil in this motor and something has gone on the crankshaft. To get the crankshaft out on this do i need to remove the whole powerhead or can i just split the crankcase by removing the front carb/manifold area? Thanks
  4. Bosunsmate

    Johnson/Evinrude 35/30/25 Engine Air passage

    Hi, I think 99% of all videos of 35Hps/30/25 hps running both on the hard and on the water seem to have the front black air guard cover off with the carburettor inlet showing uncovered. Does leaving that cover off improve performance (is the black air cover making the engine slightlyy starved)...
  5. Bosunsmate

    1980 Johnson 35 leftover part

    Re: 1980 Johnson 35 leftover part I think it may be this one Its approximately 3cm width when motor is down. Ive now done that nut up
  6. Bosunsmate

    How to install a trigger 35hp

    Re: How to install a trigger 35hp Ive had a look this morning. There is no obvious magnet on the centre hub but it does have a magnetic pull on the areas to the east west if the magnets on the outer a north south. Its much weaker than the trigger but is pulling towards the crankshaft rather...
  7. Bosunsmate

    How to install a trigger 35hp

    Hi, i have a 1980 evinrude 35hp ecsm. Im installing a trigger, they only have one. Do you want to get the edge as close to the flywheel magnets as possible without the trigger being hit? The outboard ignition troubleshooter seems to suggest you slide them closer to the crankshaft in order to get...
  8. Bosunsmate

    Evinrude 35 sparks top cylinder only

    Hi, I have a evinrude 1980 e35ecsm.Its only got spark on the top cylinder and i dont have a timing light to check if thats even sparking correctly as it really struggles to even get started on that one cylinder, although it is a decent spark. The bottom has no spark. Ive swapped coils and they...
View older results
Top