Search results

  1. S

    help choosing pitch

    90 HP four stroke<br /> fiberglass Sea Hunt 172 center console<br /> Installed Bennett trim tabs<br /> Aluminum prop is marked 12 5/8 X 21P<br /> RPM at WOT is correct at 5500 RPM<br /> Boat seems slow, top speed is 30 MPH trimed out<br /><br /> Engine specs call for a 14" diameter prop.<br /> I...
  2. S

    Riptide w/ Co-Pilot

    Any comments from owners of this trolling motor setup. Any service problems ect ?
  3. S

    Suzuki 4S service manual

    Where are service manuals available for Suzuki/Johnson late model 4 stroke EFI engines.
  4. S

    plywood hull pattern

    Can anyone provide a pattern to cut the plywood to form a "v" hull for a 17-19 foot hull.<br /> E-Mail ToyLady62@aol.com
  5. S

    sealing plywood

    Nearing compleation of rowboat built from BC plywood. Seams are sealed with epoxy resin and fiberglass tape. When applying resin to seal the remaining hull underwater is fiberglass cloth necessary, or will resin alone be enough.
  6. S

    installing new impellers

    Looking for mechanic's opinion concerning grease on a new impeller's vanes, to prevent damage on initial startup.
  7. S

    can my Force pee

    1998 40 H.P. two cylinder Force by Mercury Marine. There is a 1/8 pipe plug in the top of the water jacket. Can I run a line from this plug out the side of the case to have a pee hole and see that I have cooling water flow. What size orifice would anyone recommend that I install in the end of...
Top