Search results

  1. fordlove

    1981 MerCruiser Outdrive Water Pump

    Great, thanks for all the info, much appreciated.
  2. fordlove

    1981 MerCruiser Outdrive Water Pump

    Found this one on Amazon as an entire kit...
  3. fordlove

    1981 MerCruiser Outdrive Water Pump

    Just got to taking this apart, and looks like I have the MC-1 as it has the pre-load pin. And question about that. Once apart, I can spin the shaft and the prop does not spin. Is that because that preload pin is not engaged? Just curious.
  4. fordlove

    1981 MerCruiser Outdrive Water Pump

    Thanks for the tip. Sounds like I need to take mine apart to figure out what I have, then go from there. At least we're narrowed down, much appreciated.
  5. fordlove

    1981 MerCruiser Outdrive Water Pump

    Is that the entire water pump, or just the pump body? I'd like to replace everything to make sure I'm good to go.
  6. fordlove

    1981 MerCruiser Outdrive Water Pump

    It's hard to read the serial number off mine, it's either 3520809 or maybe first digit is 8 or 9
  7. fordlove

    1981 MerCruiser Outdrive Water Pump

    Hello all, I'm looking for a water pump for m 1981 Sea Ray. The outdrive has been replaced before I got the boat, previous owner said he locked up the old one. Any rate, I'm not 100% sure of the year or what water pump to purchase. Nearest boat shop is 65 miles away and talking to them on the...
  8. fordlove

    Mating Engine to Mercrusier problem

    So here's what I'm taking away from this. My current flywheel is part number 366861N, looking that up I get 12-3/4" Flywheel, 153 Teeth. So I need a new flywheel that will fit an '87 350, 1 pc rear seal, same diameter, same teeth. This will allow me to use my existing starter. Second, I need...
  9. fordlove

    Mating Engine to Mercrusier problem

    Ya, I need a flywheel too. So, any from NAPA should be OK?
  10. fordlove

    Mating Engine to Mercrusier problem

    Any idea what coupler I need? Maybe a part number or something I can look up?
  11. fordlove

    Mating Engine to Mercrusier problem

    I'm not sure what a votec is, and it does have centerbolt valve covers. According to Summit Racing, what they sent me was: HME-VMM6: VMM6 5.7 / 350 1987-95 GM 5.7 / 350 Complete with oil pan, front cover and valve covers installed. 2 bolt main, 1 pc rear seal, flat tappet cam, valve covers...
  12. fordlove

    Mating Engine to Mercrusier problem

    Hello all, here's my situation. I have a 1981 Sea Ray, 24ft with a 260hp 350. engine went bad, and I ordered a new from Summit. I asked specifically which engine would be a direct replacement for my year and they gave me a part number. I ordered, it arrived. Unpacked and started swapping...
Top