Search results

  1. S

    Trim tab pump and control

    Thank you. This drawing is how I believe it is currently connected. However, there isn’t any heat shrink over diodes…. And possible that there was a short on the bare wires…. Also possible that the ground is bad on the circuit…. Today, I’m going to check continuity of the switch (in open...
  2. S

    Trim tab pump and control

    Thank you. Yes. You are correct. The red would be going to the center post in your diagram powering the green or red depending on the position… The real problem starts there…. Why would I be experiencing a significant voltage drop?
  3. S

    Trim tab pump and control

    I think you’re right. I can’t find any relays in line with this circuit. However, the voltage drop happens even when the switch is open, and the motor is not engaged…. So I don’t know if this could be the cause of the problem…
  4. S

    Trim tab pump and control

    Hi all. I have a Bennet trim tab hydrolic pump running the one trim tab in my centurion wake board boat. It is controlled by a Protrim blinker style switch. I have had electrical gremlins in the boat that I was finally able to isolate to the trim motor. When it is unplugged (remove both...
Top