Search results

  1. W

    Force 50 priming solenoid

    Thanks Jerry, I think I was pretty lucky. Before I noticed the hose broken there was gas all over the motor I mean a lot of gas coming from the carb bowl and leaving a large rainbow in the water. I would like to advise everyone with these primer solenoids on 50 horsepower Force engines to check...
  2. W

    Force 50 priming solenoid

    When primer hose broke I thought the solenoid was loose but the bolt was tightened all the way and it still moves back and forth clockwise. Is this normal ??
  3. W

    Force 50-oeo62441 runs rich

    Thank you jerryjery. You have answered other posts of mine in the past and are greatly appreciated. I am taking the boat to the lake Fri. and will try this.
  4. W

    Force 50-oeo62441 runs rich

    Thank you, good info. This motor runs great at full speed. But when I lower my trolling plate it loads up real bad. I heard you could go to 60 to 1 with no harm to the motor. But i don't know if that's true
  5. W

    Force 50-oeo62441 runs rich

    My 1994 Force 50 runs very rich. Is it doable to adjust the carb on my own? It is mixed 50 to 1 now and after shutdown a lot of fuel leaks down exhaust
  6. W

    1989 Force 85 HP Starter Disengages

    Thank you, good info to know. You're the best.
  7. W

    1989 Force 85 HP Starter Disengages

    This just happened to my 50 horsepower Force. Starter would just spin and not engage. I removed the cowl and lightly tapped on the bendix, tried again and it started up. I have never cleaned one these before but I think I'm gonna try.
  8. W

    Impleller Help Needed

    Hello everyone, kinda new here. i m changing the impeller on my force 50 hp and the driveshaft has a rubber boot and collar just under the upper splines and seems to be on very tight. cant get the impeller off without removing this, dont want to destroy it. any help appreciated. Thank you
  9. W

    Can a bad volt reg. or cdi cause 50 hp force stator to go bad??

    I changed the stator in my 1993 50 hp force. 2 blue wires tested no ohms at all and red wires tested 95 ohms and yellows were 1.4 ohms. I found a used stator and it tested reds at 97 ohms and blues were 1140 ohms. seems really high. I don't know if this even work. byw, yellows are 1.4 ohms. Is...
  10. W

    changed stator-still no spark

    a local outboard mechanic tested the stator on my 1993 50 hp force-0e062441- and said 1 side was bad. so I found one on line at franz marine and installed it. still no spark. I really don't know how to proceed from here to test other components without just buying and replacing cdi, rectifier...
  11. W

    Fuel Pump Kit

    does anyone know where I can get a fuel pump rebuild kit for my 1994 force 50 ser. no. 0E0 62441. my local dealer says it is no longer available.
Top