Search results

  1. JJB

    quick start on 2000 175 Johnson

    I have a question about my quick start system on my 2000 175 Johnson . When I start it cold , it start right up but seems to run ruff until the quick start circuit shut off in about 1min or so ( I am in fl ) the power pack is only a yr old and omc replacment .Thanks for the input . JJB
  2. JJB

    leak down test

    I wanted to get some info about a leak down test . I have a 2000 175 johnson Ob two stroke . When I was doing the leak down on one cyl , If I removed a plug from any other cyl during the test I could hear air comming out of it as soon as I turn on the air pressure , is this normal for that...
  3. JJB

    Max spec. Height of the engine to fuel tank ?

    I wanted to know if there is a max spec. for a outboard motor height to it's gas tank ? I have a 2000 175 Johnson . what would be the lift ability of the fuel pump ? Is there a way to check the fuel pump vac on the fuel line going into the tank ? Thanks for the input JJB
  4. JJB

    2000 175 johnson stall question

    My 175 hp runs great and has a good idle for the first few hrs but as the day went on it starts to spit or stall at low rpms . When I get back to the dock it will stall when I try to dock it or if I rev it fast to get it on the trailer it will also stall . Thanks for the input ! JJB
  5. JJB

    2000 175 johnson Block question with pictures

    I have a block with some good size gouges in the bearing journals lower half, can it be repaired and used in a rebuild ?Can I leave the gouges in the journals or would the gouges effect the performance , The crankshaft bearings lay in the journals ok but I don't have a good enough understand...
  6. JJB

    yamaha 115 four stroke starter battery

    I want to get a my battery on my 115 four stroke . I dont know the starter current and I don't have the manual for it . can you use a deep cell / starting type of battery with that engine .
  7. JJB

    comp test on a 2000 175

    I took a compression test on my motor and it was 100, 100, 90 , on the port side and 110 , 110 , 110 , strb side . Is this acceptable for commpression range ???
  8. JJB

    2000 175 Johnson carb question

    I wanted to know if having my carb floats set to high will make my motor smoke excessively . It seems to run strong , starts up good with compression of 100 100 90 port 110 110 110 strb . Thanks for the input !
  9. JJB

    2000 175 Johnson carb question

    I wanted to know if there is a aftermarket or different yr Johnson 175 metal type carbs I can replace the plastic ones that come on the Johnson 2000 175 .
  10. JJB

    E-Tec 150 or 175

    I wanted to get some input about the new e-tec 150 vrs the 175 e - tec . they are just about the same engine weight etc . How do they get the extra 25 hp out of it ? someone said the 175 are dogs compared to the 150 . ANY know issues out here ? any input would be a great help looking to repower...
  11. JJB

    suzuki vrs e-tec for repower

    I am looking to repower my 20' cc boat with a 140 suzuki or a 150 e-tec . I do a lot of offshore trolling so I was thinking the 4 stroke be better . I am interested in any input or opinions about issues with the 140 suzuki or the 150 e-tec .
  12. JJB

    2000 175 Johnson shift sw adJ

    I have a 2000 175 Johnson ob and need to adj the shift assist sw . I know it suppose to drop a cyl when shifting from Netural into gear . Can someone tell how to adj it so it works right and when it should engage ? Thanks JJB
  13. JJB

    Fuel restriction

    I have 2000 Johnson 175 carbed outboard on 1991 20 ' trophy bayliner . I been getting a fuel restriction alarm when I am running 3000 rpm and above but not all the time . Sometimes primer ball will flatten when I run over 3000 rpms . It has a new fuel pump , filter , and primer bulb and hoses ...
  14. JJB

    Tilt and trim rebuild

    I just replaced the rod cap and gaskets in the tilt cyl part of my 2000 175 johnson TNT unit . It had a leak around the tilt shaft the trim cyl were ok so I never touch them . I have the unit off the boat and am bench testing it now . The tilt piston is working good and goes up and down but the...
  15. JJB

    converting to suzuki

    I now have a 2000 150 Johnson with a new type bombar top mount shifter with trim control and key sw combo binnical control . I am thinking about getting a new suzuki Df 140 and wanted to know if my wiring harness and controls can be used or am I going need all new ?
  16. JJB

    wiring harness adpt .

    I have a 2000 175 johnson installed now with the new type wiring system and harness on the boat. If I wanted to install a older evinrude or johnson 150 or 175 motor is there a adpt for the wiring harness from the boat to the old style thats on the motor I can get ?
  17. JJB

    Johnson interchanging parts 1996 -2000

    Does anyone know if power heads parts from 1996 - 2000 150 Johnson are the same ? what is the difference between the 150 and 175? block porting ?? are 150 -175 crankshafts and rods the same ? Can the lower units be interchange throughout 1996 -2000 ? Thanks for the input !
  18. JJB

    re jetting after rebuilding

    I wanted to know if you should re jet your carbs after rebuilding a 2000 175 johnson . .30 over ?? crowely recomended .0002 up on the jets
  19. JJB

    boyesens reeds

    I wanted to know if boyesens reeds give you better idle and better for trolling ? DO they increase mpg also ? I have a 2000 Johnson 175
  20. JJB

    Df 140 suzuki input

    Looking for some input on the new Df 140 suzuki . Could this engine handle a 20 ' bayliner 2800 lb boat with a deep v hull . Not looking for great speed just avg 33 mph like the 150 force that came off it .
Top