The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
At low speed it chugs. At first, I thought it was slipping in the trans but it is not. At idle and anything higher than low, it is fine. It might be smoking a little more than it should at idle. Where should i start?
When first started, I will have to feather the throtle in order to keep the engine from stalling out. It will run fine at first when I open it up but will eventually start to go through a phase in which it surges then bogs down then surges and bogs down the RPM's will drop and surge to where...
Has anyone built thier own trailer before?<br />I am thinking about building my own for a 18 ft bow rider. It needs to handle about 2800#. I need to know the best way to go about begining this adventure. I have seen some frames but am not sure if they can handle the weight. How can I tell...
I am looking for a used trailer that can handle an 18 footer and can hold 2500-2800lbs. Does anyone have any suggestions for sites or locations? If they are in the mid west, even better. Thanks for the info gang.<br />Dewey
forester 1800 rio. I thought that there was a forester boat company but all I come up with is forester pontoons. Any information would be greatly appreciated. thanks
I have a 1960 60 hp sea king engine and i found a 14 foot Sea king boat runabout style that someone is selling(1960?). Would this motor be to large for the boat. It seats four, has a yellow top white bottom, windshield, and steering. Any information on the boat would be appreciated but i am...
I have been working with this engine since may and have made great leaps and bounds but since I have installed a tach I have realized that the engine is not running at the right rpms. The model is GG8850A it is a V4. It is supposed to run at 4000-5000 RPM (60hp at 4500). It was only running...
I have been told to use any one of these. In my manual I was told not to use hypoid 90. Instead I am suposed to use OMC type "b". I was wondering what the differences were between the three that I have been told to use and if there is one that is better for this application. Thanks for any info.
There is a hot light on the dash and also a temp gauge. Neither are hooked up and the temp gauge wires come out by the shifter and throttle lever box. What wire should go to the hot light? I have the manual for the motor and it does not indicate any thing for these. For the temp gauge, where...
Hi gang,<br />I have a 1960 60 hp Sea king (Gale division of OMC)model #GG8850A. It runs off a magneto and is a v4. I was wondering what type of tachometer i need to get and how to wire it if it is not in the instructions. There was no original tachometer. let me know if more info is needed...
I have not seen OMC Type "B" Gear Grease. Is there an alternative? I have a 1960 60 HP Sea King. I have been told it is a 50 HP upper and 75 HP lower unit for that year. It is not an electrical shift. Any help is greatly appreciated.
I am not getting any spark for my plugs. There is a little bit of a charge going to it when I try to start it. Should there be a charge going through the lead to the magneto? If so how much? Is there any other things i can check for? The points seem to be in good shape. There is no short...
I would greatly appreciate any information I could get on my motor. The Model # is GG8850A. I know that it is a sea king and that it was probably made in the 60's sometime. I have not been able to locate it in any of the old outboard maintenance manual books. It seems like this model was...