The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I ordered seirra pump housing kit 18-3317 to replace my existing pump assembly and I noticed the sierra kit does not have a oil or face seal on the water pump body. the existing pump assembly has a seal in the body. My question is do I need to order this item seperately for this specific kit...
where do you carry extra fuel in 5 gal cans? Inside the boat or on the swim platform? I would like to take 10-20 gallons of extra fuel in 5 gal cans. I think the swim platform would work best for me. What do you do? any safety issues?
I have a lifter ticking on a 1973 slickcraft ss-235 with twin mercruiser 140 4 cylinder engines. It is a stern drive. The engine block has a side plate that can be removed. I was told the lifter can be replaced when the side plate is removed. Anyone have instructions or done this before?
Currentl prop size is 13 3/4" 21P. WOT 3900rpms @ around 38mph.
The elevation is at 3600 feet. Boat loaded with gear and 3-4 people. What prop size and pitch would be the best to bring it into the recommended rpm range? Is the current prop sizes causing to much of a load on the twin merc...
I removed the props from my 1973 slickcraft SS 235 with twin mercruiser 140 motors and outdives. When I returned to install them on the drive shaft I installed the thrust washer, propeller, castle nut, lock washer and then the nut. I noticed the castle nut would not slide over the splines of...