The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
Hello All,
I just got my 1988 Angler CC repowered with a 2006 (left over) 140 Suzuki motor. I also got a 6 year warranty with the motor. We did a brief sea trial
at the marina. All I can say is unbeleiveable. The engine is so quiet and my boat planes alot faster than my 84 115 Johnson. I am...
Hello Guys,
I have an 18 ft 1988 Angler CC with a 1984 115 Johnson. I have been having a problem lately with the motor thumping when under way. It feels like I hit something in the water and it happens about every two minutes. It does not kick up the engine but its strong enough for my wife to...
Hello All,
I have a 1988 Angler 18' CC with a 115 Johnson. I got a good deal on the boat and it was very neglected from the previous owner. I was debating on painting the whole boat because of age and oxidation from the Florida sun. Its a two tone white and gray hull. Well, I decided to wet...
Hello,<br /><br />I just got finished installing a new Water Pump kit and wanted to know if there is a little play on the impeller shaft when installing it with the plastic key? It looks like there is only one way to install the impeller on the shaft with that plastic key. The o-ring gets in the...
Hey Guys,<br /><br />1984 Johnson 115 Hp V4. Just got done doing the thermostats cleaned heads etc. When idling my tempature gauge rises to 210 degrees and higher, but the warning horn does not sound.<br />I can hold my fingers on top of each head and count to 5 without burning them.<br />The...
Hey Guys,<br /><br />I have a 1984 Johnson 115 Hp V4 on a 1988 18Ft Angler CC. Just bought the boat. It ran fine on a sea test when purchasing. It still runs fine now, but when I run the motor more than 3000 rpms the warning buzzer sounds and stays on until I throttle down to idle. The motor has...
Hey Guys, I wanted some opinions on painting the bottom of my 18'center console Angler. I Just bought the boat and there was antifouling paint on previously.I sanded it all off and found alot of gashes, chips and scratches in the gelcoat. I repaired the gelcoat but could not get the color to...
