Search results

  1. K

    Repairing a boat cover

    I'm repairing the cover on a 20' Four Winns I just bought. First I'm replacing the snaps on the hull then I plan on doing some repair to the cover itself. Then I will use the snaps on the hull to mark the locations for new snaps on the cover. Question: 1) What is the best way to get the old...
  2. K

    How far can you raise an 87 OMC 4.3 while changing motor mounts?

    How far can I jack up the front of the engine without damaging anything. I need to replace the motor mounts. 4.3 ltr V6 I/O. I put a small car jack under flywheel and raised the motor just enough to take the load off the motor mounts. I got out the 4 wood screws that held the motor mounts to the...
  3. K

    Where can I buy a Key Resistor for OMC 4.3?

    Where can I buy a "Key Resistor" for OMC 4.3? Test per the book says might be bad. And where is it on the boat? Thanks Kip
  4. K

    OMC stalls and hard to idle when hot

    OMC 4.3 V6 2bbl rochester carb Starts and runs great when cold and for a couple of hours. Then is hard to idle and stalls. Temp on dash is fine. Timing and dwell are dead on. 6 deg BTDC and 39 deg Plugs are just a little rich looking The resistance through the coil (disconnected) is 2 ohms...
View older results
Top