Search results

  1. H

    Problems starting after fuel filter/water separator change

    Okay everyone. So I hooked a hose up the schrader valve, and when we cycled the key, pure fuel came out. After doing that a few times, I hooked up a pressure gauge, and I am getting 30 PSI. Coil has 12v when key is “On”. Going to test with a real spark tester next.
  2. H

    Problems starting after fuel filter/water separator change

    I will check this today -- ty!
  3. H

    Problems starting after fuel filter/water separator change

    Are you referring to the red switch at the controller? If so, yes I confirmed.
  4. H

    Problems starting after fuel filter/water separator change

    Thanks for the reply! I am leaning towards the need to bleed air. What does the HP bleed port look like? If it doesn't have one, do I just hook up a hose to the Schrader valve to bleed at the rail? I was thinking hookup a hose to the Schrader valve into a bucket, temporarily hookup a primer...
  5. H

    Problems starting after fuel filter/water separator change

    I recently changed the fuel filter/water separator on my “new to me” boat. I filled the new filter with fresh gas before installing. I then launched the boat, started the boat, and drove it to the dock from the ramp. It sat for about 2 days, and now only cranks with no start. I have since...
  6. H

    RE: 1996 Mecury Force 120HP

    It was all in one piece. I am going to replace it today, will update after.
  7. H

    RE: 1996 Mecury Force 120HP

    Howdy Yall. I recently replaced the thermostat in my engine. I ensured it was an exact replacement and that it was installed correctly. However, I’ve noticed that the “pee hole” after the thermostat has intermittent flow. I am assuming because it is after the thermostat, what I am seeing is when...
View older results
Top