Search results

  1. mbhoag

    Fuel Usage - 1986 Force 125 on 18' bayliner bass boat

    OK, This summer I purchased an 86 Bayliner Bass boat with an 86 Force 125. Filled up the gas tank (I am guessing 20 gallon) with fresh gas and have now had it out on the water 3 times. I have only been on a small no-wake lake and had engine running a total of 4-5 hours at pretty much idle...
  2. mbhoag

    I put the plug in...honest!

    New boat to me this summer, 1st trip to water to check running of motor, leaks, bilge pump and live well, etc. No issues, a few things to be replaced such as bilge pump and livewell pump..both dead in the water (pun intended). Not a single leak of hint of water in the bilge! Hooray!. Second...
  3. mbhoag

    86 Force 125 Volt Meter Question

    I'm a tad confused on the voltmeter on my boat. Doing some updates and am want to make sure this gauge is giving me good info. 1. Is this gauge normally wired to the rectifier so that it is giving engine voltage, or is it showing voltage at the battery? 2. Assuming it is showing battery...
  4. mbhoag

    86 Force 125 adding Temp Guage and Water Pressure guage

    I want to add both a temp gauge and water pressure gauge to my 86 Force 125. Just purchased boat and have spent time and money getting it running great, so want to make sure I have no issues. 1. Is this the correct port that I can install a water pressure gauge in? (see arrow in image) 2. Will...
  5. mbhoag

    1986 Force 125 Lower end gear lube change

    I am working on my 1986 Force 125 that I recently purchased, changed the water pump impeller, installed a new stator and Packs (stator and 1 pack were bad) and I have 2 things left to do... 1. I need to change the lower end gear lube, but I have been through every Allen wrench I own and cannot...
View older results
Top