Search results

  1. C

    Black max temperature sensors

    Yeah both sensors are held in with a bracket with 2 bolts. The starboard pushes in with a rubber grommet and has a coil spring on it. The port side is 1/8 pipe thread with the same kind of bracket. I’ll trace down that wire and see if it’s open. I’d say it is. Thanks
  2. C

    Black max temperature sensors

    The starboard side sensor went to a junction block with a tan wire that runs through the harness connector But I couldn’t find anything for the port sensor. I see a pinkish bullet connector on the starboard side of the harness that could have been ran at one time but wasn’
  3. C

    9 amp to 16 amp stator overcharging

    Finally getting everything worked out on this motor. Stator was bad and thought it was the 16 amp stator but turns out it was a 9 amp. My engine only has the small square rectifier. It is overcharging the battery. Maxed out the gauge at 16 volts. I don’t want to burn anything up. Can I add a...
  4. C

    Black max temperature sensors

    The one on the starboard side is a tan wire. I traced it to the controls for an alarm. Is there a wire in the factory harness for the port side for a gauge?
  5. C

    Black max temperature sensors

  6. C

    Black max temperature sensors

  7. C

    Black max temperature sensors

    It was on it when I got it. I took it off and it looks like it just touches the block. Doesn’t look like water comes through it. What wire does this use to go up to the front of the boat
  8. C

    Black max temperature sensors

    It’s an 84 150. Couldn’t find one with the smaller thread pitch. Will keep looking thanks
  9. C

    Black max temperature sensors

  10. C

    Black max temperature sensors

    I’m gonna install a gauge. Is the port side sensor a 2 wire? Mine is broke
  11. C

    Black max temperature sensors

    I have 2 sensors. One on port side with a stud the one on starboard has a wire attatched to it with a coil of wires. Which is for the alarm and which is for the gauge? Thanks
  12. C

    mercury blackmax 150 power/wot problems

    I’m almost certain it’s fixed. I can adjust idle and it throttles very easy now. My bottom carburetor had the primer fitting on it and it was routed to the middle bleed valve. I moved carburetor to the correct position. And put that one into the primer solenoid. Then routed that bleed valve to...
  13. C

    mercury blackmax 150 power/wot problems

    I got a seloc and someone gave me one for a newer model for the link and sync
  14. C

    mercury blackmax 150 power/wot problems

    I have primer lines going into 2 places on the top carburetor right now. Bottom left and top on the tee
  15. C

    mercury blackmax 150 power/wot problems

    And bottom moved to the top? There is a fitting on the bottom of the bottom carb. I believe that’s where the primer goes?
  16. C

    mercury blackmax 150 power/wot problems

    Fuel lines and primer lines need to be fixed. And the bleed line
  17. C

    mercury blackmax 150 power/wot problems

    I thought so. The guy I bought it from said he put different carbs on it
  18. C

    mercury blackmax 150 power/wot problems

  19. C

    mercury blackmax 150 power/wot problems

  20. C

    mercury blackmax 150 power/wot problems

Top