Recent content by yesizmatt

  1. Y

    30hp Mariner Wont Turn Off

    Hello my boat motor is a Mariner 30hp unknown year, the plate on the outboard says MARINER 30E 689 L 404450. The motor runs great but the other night the engine would not turn off when I turned the switch to the off position. The kill switch lanyard does not work either, but it was not...
  2. Y

    120hp Mercury No Sprark

    Hello everyone I really need some help figuring this out as I am out of ideas of what could be going wrong. I have a 1995 mercury sport jet 120hp, and It is not getting spark. I have replaced the stator, and the switchbox, and still nothing. Once in a while it will spark but then when you take...
  3. Y

    Very Odd WOT Speed Problem Mercury Sportjet 120 1995

    I had the boat out today and it doesnt hold a high rpm at wot. This is exactly what happens: -From idle to wot boat speeds up all the way and has good rpm -a few seconds later the boat slows down and looses some rpm -occasionally it will pick up and go and then go back down. This leads me to...
  4. Y

    1995 Mercury Sportjet 120hp bottom carb problem

    I have been working on a 1995 mercury sportjet 120hp and have good spark and compression on all cylinders. The engine hasn't been running very good and after doing tests I found out that the bottom 2 cylinders are not getting fuel, since the spark plugs are dry. This leads me to believe...
  5. Y

    Evinrude Fleetwin High Speed Needle Problem

    I have been fixing up my 56' evinrude fleetwin and it has been running better lately. The final problem that I have is tuning in the high speed control. When I go up to full speed, it does not go very fast at all, maybe 1/4 the speed it should be going. Then as I turn it in slowly waiting for it...
  6. Y

    1957 Evinrude Fleetwin Carb Problem

    Re: 1957 Evinrude Fleetwin Carb Problem Here are some pictures of the fuel pump and how I have it setup.
  7. Y

    1957 Evinrude Fleetwin Carb Problem

    My evinrude will not run very good at all. If I do get it to start (take around 5-10 pulls) it will only stay running for around 10-15 seconds, and can not idle low, or be put into gear without it dying. I have replaced coils, points, and spark plugs so those are not the problem, but I believe...
  8. Y

    Evinrude Fleetwin 7.5 Base Gasket

    I need a new base gasket for my 1957 evinrude fleetwin 7.5hp. I can't find one anywhere does anyone know where to buy a base gasket that will fit this motor?
  9. Y

    Why do Points Need to be Spotless?

    From what I have read the points in a flywheel need to be spotless, and cant even have a fingerprint on them. I am just curious why since to my understanding electricity just goes through them. If anyone can explain this to me it would be greatly appreciated.
  10. Y

    Evinrude Fleetwin 7.5 57' Possible Flywheel Problem??

    I have been having trouble getting my evinrude fleetwin running for a good amount of time now. In a past thread, I have posted about this and concluded from the help of others that I should purchase new coils and replace them. Once I replaced the coils and tried to run it again, the same problem...
  11. Y

    Different Props that fit on an 57' Evinrude Fleetwin 7.5

    I have seen pictures of people with newer looking propellers on their evinrude fleetwins and was wondering what other propellers fit on them? I uploaded a picture of a picture i saw online with a new prop.
  12. Y

    Evinrude Fleetwin 7.5 Spark Plug Problem

    I know a moderate amount about outboard engines and am currently fixing a 1957 evinrude fleetwin 7.5hp. I am testing the spark plugs and they spark, but were touching eachother. When I tried to see if they would spark when not touching eachother, their is no spark at all. I have never heard of...
  13. Y

    1957 7.5hp Evinrude Fleetwin Fuel Tank Problem

    I have a 1957 7.5hp Evinrude Fleetwin with the old style fuel line that has a gas and air line. I have noticed that when the gas tank is higher in the boat, the motor is more responsive and much faster. Any reason why this happens and is there something wrong?
Top