FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Hello,
I have an old 90hp Chrysler Outboard that won't seem to fire up. It will fire when a small spray of starting fluid is used. After it's started it runs just fine on regular 50:1 mix. I have replaced the plugs and wires with new ones and got the timing to factory specs where it should fire...
I am trying to locate the engine's kill / stop switch. The manual shows two black wires one each leading to a seperate point on the ignition system however there aren't any black wires on mine. Can anybody tell me if it had one and it was taken off and if so can I wire up a universal kill switch?
