FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Hi guys,
I recently installed a seal kit in my motor - a 1986 Evinrude 15 HP (E15RCDE).
The water intake screen (BRP-0318991) was dry rotted and fell apart.
I looked online for one but everyone says they're obsolete/vintage and out of production.
Does anyone know where i can get one of these?
I have a J200TXEOC with a driveshaft stuck in the crankshaft. All bolts are out and shifter is uncoupled. Lower unit moves a little side to side and front to bacl but only about 1/8 inch up and down. The motor was used in salt water.
How do i get the shaft unstuck?
I just got an OMC charging kit (0174037) for my motor and noticed that there is no regulator. It has a stator and a rectifier. I have heard that charging batteries without a regulator can damage them. Does anybody know if i am supposed to have a regulator?
Hi all,
I have a 1995 Johnson 200. I recently replaced a failing stator (the leaking goo problem) and the regulator/rectifier. After the initial startup, the system was charging at 13.5 V. I went out to check it this weekend and it isn't charging at all. Other than disconnecting the battery or...
I'm having a problem with the built-in 115 gal. fuel tank. It takes a lot of pumping to raise the gas and loses prime when i trailer the boat.
The tank sits about 2 feet below the fuel pump. There is a water sep filter on the transom at the same height as the fuel pump. The primer bulb is...
Re: 1995 Johnson 200 won't start without fully charged battery
I checked the blowoff valve this morning and sure enough it had seaweed or something clogging it. So, from what i read, the clogged valve caused an air pocket to form which in turn caused the regulator to overheat which ultimately...
Hi guys, i appreciate all the good info on this forum and any help you can give me.
I bought this motor used to push a Sea Ox 23c and it runs really good except for this nasty problem i'm having with cold starting it.
If i let the boat sit for a few days, i have to charge the battery up to a...