FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Tach don't work. Replaced rectifier. Read alot of serches. Next step is stator.
Disconnect yellow wires and should be 20 plus AC volts?
Motor runs well and is charging.
Boat is 250 miles away from here. Trying to go prepaired.
Any suggestions? Tom
1989 Evinrude 200hp. Just installed original rectifier.One less wire,purple. Motor runs and is charging.
Tach does not move. Any suggestions. Thanks Tom
Have search and read many pages of NO SPARK
Trigger voltage should be 4vt, it's 2vt.
Trigger ohms should be 1100-1400 or 11 to 14.
my auto ranging DVM says 1.2 to 1.3 K ohms. Is this a correct reading?
Stator test
Blue lead to red lead (low speed) ohms should be3.6 to 4.2, meter says...
90HP,89,2-stroke. Stored for ten years.Went through entire fuel system and plugs.
Idles along great. But it will drop a cylinder for a minute and then come back. When it drops a cylinder it is diffidently running on two cyl, will not get on plane. Then it kicks in the third cyl.
Going to...
Motor sat for ten years. Just did carbs and fuel pump and replaced oil lines.
Fired off and runs great. But no oil being pulled into pump. Disconnected linkage on oil pump and advanced it. It sucked oil pretty good.
Tried it again a week later, will not pull oil no matter what I do.
Is there...
