Hi Guys,
Just bought this motor and boat... took it out all day (trial run).. runs great.. stated and stop all day.. ran for miles without any trouble... Starts right up hot or cold... My question----- On trial run I noticed time where tell tail was peeing water and a lot of times it wasn't...
Hi Guys, I have a 2003 150 Mercury ob with trim/tilt.. The motor has the switch on the side of the motor and it works well... I want to add a trim/tilt switch in my dash... Is it possible to jump into the existing wiring somewhere and add the switch? Or should there be a plug on the harness...
1) when I have my stringers all glassed in should I add wax to my last coat of poly so it cures properly? 2) do I have to sand thought all the gel coat where I'm tabbing the floor to the deck? 3) I watched a few videos completely removing the deck cap and cutting and removing the back portion...
I have a 83, 17 foot bass boat.. I removed the stringers & floor.. Been reading, watching & called my supplier with questions on the best way to rebuild.. I'm replacing the stringers with 3/4 ABX & 5/8 on the floor.. I've see, read & been told a dozen ways to proceed.. I understand poly & mat...
