FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I just did. I didn’t get it up to the high rpm the alarm sounds at due to my water muffs not being the greatest(tons of water spill out of them and the tell tail stream is not as strong as when in the water) but I ran it at about 3500-4000 rpm for about 5-7 minutes and never got the alarm my...
Would you suggest starting with a lower unit rebuild? As far as I’m aware the engine is where it was installed at the factory(no jack plate) and I run it with the trim all the way down. The water pressure gauge on the console does jump up and down a little when I’m running at the rpm I’m getting...
I recently bought a 1988 bass tracker with a 45hp mercury 2 stroke. The motor runs well but when it gets around 5500 rpm I get a continuous beep indicating a overheat after about 5-10 seconds and when I let off the throttle the alarm stops. The motor has a solid stream from the tell tail the...
