Hi all.
I've got a couple very basic questions geared towards someone new to purposely running skinny. Gonna give yall some context first. I typically fish the Snake River in Southwest Idaho and Eastern Oregon. I've heard it's comparable to the Susquehanna among many others. Rocky. Sketchy...
Yes.. Could be. Just figured id put it somewhere where there was more activity.
Anways. I have a 80lb 52" shaft Ultrex with built in MDI.
I realize I need to purchase a Graph that will support said Mega Down Imaging if i want to use that feature. So im looking at a model such as Gen4 Helix 12...
I thought i deleted the original one. The original postings forum section was dead.
And i believe you know what I mean. Theres a way people run Built in MDI in addition to transducer off the back. I want to use both transducers. Just randomly buying a $2000 unit and hoping everything works is...
Hi yall.
Ive searched high and low, asked everybody i know. Cant seem to get a solid answer.
New Ultrex with built-in MDI is going on new boat. Shopping for graphs. Humminbird. Clearly I need a DI compatible graph if i want to use the built in MDI on the Ultrex... But, I need to run a transducer...
Hi yall.
Ive searched high and low, asked everybody i know. Cant seem to get a solid answer.
New Ultrex with built-in MDI is going on new boat. Shopping for graphs. Humminbird. Clearly I need a DI compatible graph. But, I need to run a transducer off the transom so I have data and GPS while...
I did in fact take that into account. I had a nice cool water supply running into the bucket to offset any heated water and/or exhaust below the waterline.
Ill look into getting a flush plug adaptor. Wish I had a local dealer...
Thanks for your commentary.
Right on thanks.
I am also uncertain of the path the cooling water takes in this engine. Could only find service manual for 4hp and up and those didnt provide too much information.
I was told this was a freshwater engine. No exterior evidence of salt/corrosion.
The chamber in which the...
Thanks for the reply. I may invest in an IR gun. Was using a multimeter with a temp probe when getting my measurements. Requires taping the end of the wire to an area to get a reading and this engine is tiny.
But with everything being said, and everything thats been verified, if i do...
Good day yall.
So long story short, ive got a new to me 2007 Tohatsu 3.5hp 4 stroke long shaft tiller. Seemed to run fine at time of purchase, but the man had limited time so I checked compression and all the obvious and purchased it. From what I was TOLD, this motor was a dock navigator on...
Quick and simple. Old post is lost and burried. New to me 1995 Johnson 48hp SPL. Purchased a tachometer from the shop when I bought the motor. Dial on the back was set to 5 when I picked it up, but it was an after hours accessory install done in a hurry. I dont seem to crest ~4700 RPM @ WOT...