FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Ok been slowly pretty much rebuilding this motor since I got it like 7 months ago or so....
Here's whats up with it now... When I purchased the motor and checked the compression, it was 111,115,113,111.
Now I checked the compression and it and cylinders read right around 78 +/- 1... What the...
Hello, First let me say I apologize for the length.. but I have a 1987 Evinrude 100hp Commercial outboard...
Been working on it/restoring it and stuff for a few months now(slow process I know).
Anyways, I have a couple questions regarding the motor and some of them are just me being a little...
Hello, have a 87 evinrude 100hp commercial model.
Previous owner ripped the boot off the end of the power pack wire that connected to the coil.
I bought a new boot and connector but while trying to install ripped the wire so now it's an inch to short.
Can I splice about a 4 inch piece of wire in...
Probably dumb question but, restoring boat and it still had the old fuel filter/ water separator attached to it.
It's a parker racor 320r-rac-01 with the racor s3227 filter. This hooked up to a Yamaha 115. Not sure if it was 2 stroke or 4 stroke.
I put a 100 evinrude on it that used to have VRO...
Ok made a thread to ID my outboard now that I know its a 87 100hp evinrude on to the next problem.
I got the motor and boat at a great deal due to what the guy thought was a bad starter and bad tilt/trim.
The tilt/trim needed fluid and wasn't grounded so was a easy fix.
However being that he...
So bought this package deal that came with a 1989 bass tracker and a outboard motor.
Owner was not sure of the HP so stated it was a 115 Johnson from 1987.
Johnson didn't make a 115 in 1987 so when I went to look at it looked around for a id tag.
Found one on the tilt/trim assembly.
It states...
Hello.... I need some help/advice/suggestions/ideas on my 1986 Honda BF75 (7.5hp) 4 Stroke motor.
Ok so here it goes... Got the motor with a boat few months back. When I got the motor it didn't run
due to carb being dirty. I took the carb apart and cleaned it and got it running within the first...
Hello let me first apologize for this being so long but I know as much knowledge as possible helps troubleshoot so let me just say thank you for your patience.
As you can see I am new to this website but I have been on here a lot reading previous posts and have got a lot of knowledge and...
