Search results

  1. T

    1987 evinrude 100hp - Compression good then a major drop in all cylinders?

    Ok been slowly pretty much rebuilding this motor since I got it like 7 months ago or so.... Here's whats up with it now... When I purchased the motor and checked the compression, it was 111,115,113,111. Now I checked the compression and it and cylinders read right around 78 +/- 1... What the...
  2. T

    1987 Evinrude 100hp - Need help regarding way it starts/runs and possibly overheating

    Hello, First let me say I apologize for the length.. but I have a 1987 Evinrude 100hp Commercial outboard... Been working on it/restoring it and stuff for a few months now(slow process I know). Anyways, I have a couple questions regarding the motor and some of them are just me being a little...
  3. T

    Can you splice the power pack wire that goes to the coil? 100hp Evinrude

    Hello, have a 87 evinrude 100hp commercial model. Previous owner ripped the boot off the end of the power pack wire that connected to the coil. I bought a new boot and connector but while trying to install ripped the wire so now it's an inch to short. Can I splice about a 4 inch piece of wire in...
  4. T

    Need info on fuel filter/ water separator. Will it remove 2 stroke or is it safe?

    Probably dumb question but, restoring boat and it still had the old fuel filter/ water separator attached to it. It's a parker racor 320r-rac-01 with the racor s3227 filter. This hooked up to a Yamaha 115. Not sure if it was 2 stroke or 4 stroke. I put a 100 evinrude on it that used to have VRO...
  5. T

    1987 Evinrude 100hp outboard with Starter problem. Maybe wired wrong?

    Ok made a thread to ID my outboard now that I know its a 87 100hp evinrude on to the next problem. I got the motor and boat at a great deal due to what the guy thought was a bad starter and bad tilt/trim. The tilt/trim needed fluid and wasn't grounded so was a easy fix. However being that he...
  6. T

    deleted

    deleted due to error sorry
  7. T

    Need help identifying Johnson or Evinrude 100-115hp Outboard

    So bought this package deal that came with a 1989 bass tracker and a outboard motor. Owner was not sure of the HP so stated it was a 115 Johnson from 1987. Johnson didn't make a 115 in 1987 so when I went to look at it looked around for a id tag. Found one on the tilt/trim assembly. It states...
  8. T

    Need help/advice/ideas on 1986 Honda BF75 (7.5hp) 4 Stroke motor not starting/running

    Hello.... I need some help/advice/suggestions/ideas on my 1986 Honda BF75 (7.5hp) 4 Stroke motor. Ok so here it goes... Got the motor with a boat few months back. When I got the motor it didn't run due to carb being dirty. I took the carb apart and cleaned it and got it running within the first...
  9. T

    93 Force 50hp Gears/Shifting/Vibration issues after changing Impeller and gear lube.

    Hello let me first apologize for this being so long but I know as much knowledge as possible helps troubleshoot so let me just say thank you for your patience. As you can see I am new to this website but I have been on here a lot reading previous posts and have got a lot of knowledge and...
Top