Recent content by tommegna

  1. T

    Trollmaster Wiring Help.

    Does anyone have a wiring diagram for a trollmaster analog hand held controller. The problem is that the wires were corroded and I'm not sure what order to solder them back on. There are 4 wires and 5 pins There is a red, white, black, and green wire. If anyone would be able to draw a diagram...
  2. T

    troubleshooting the tilt & trim on a 2003 Mercury 9.9 HP BIGFOOT 4 Stroke 25"shaft

    troubleshooting the tilt & trim on a 2003 Mercury 9.9 HP BIGFOOT 4 Stroke 25"shaft I wondered if anyone would have a wiring diagram for the trim/tilt on my Mercury Outboard. 2003 9.9 HP BIGFOOT KICKER 25" shaft. I don't seem to have power to my single side mount control for the trim. Any...
  3. T

    Constant problem with bad sensors in oil tank for 2003 200 hp efi

    Is there a solution to fixing every other year of buying a new oil tank for my motor. Has anyone bought the sensors separately. Seems like I get beeps and there gores another $100.00. Any help or thoughts would be deeply appreciated. Thanks, Capt. Tom Megna
  4. T

    1989 40 hp evinrude won't start

    NEED HELP ? 1989 40 HP Evinrude Outboard won't start. Where do I start. The fuel line and ball stays hard. It's brand new. I looked at the fuel pump and cleaned it out. Did not replace filter, just cleaned it. Put new spark plugs in. I didn't check for spark, but it was running yesterday, The...
  5. T

    lower gearcase reassembly

    I replaced the seals and o-rings in the lower gearcases of a 40 HP 1989 Evinrude Outboard and reassembled the lower until and now the gears won't engage the Prop Shaft. Any help is deeply appreciated Tight Lines CAPTAIN TOM MEGNA
See more
Top