FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
At what speed should I expect my sounder to stop functioning. I have a Navman 4350 sounder, which performs well, but at any speed above a fast idle, it ceases to work. the transducer is mounted as per the manafacturers specifications, but the old sounder had a drop down plate mounted to the...
Has anyone installed a Navman fuel flow sender in their boat, the type that connects to your GPS. I am unsure if I can put a fuel guage in my tank and need to keep track of fuel level. I have a 75 ltr plastic tank with no fittings for a sender unless i cut a hole in the tank, then have to screw...
I have a Rule 360 GPH bilge pump that I want to connect to mains power through an inverter/converter, what is the amperage draw on these pumps so I know what converter I need. The pump is being used by my daughter for a school project and it is a pain having to lug a battery around, and I want...
Hi All, what would cause an OMS Pump to click constantly whilst at idle. I understand that the click is an indication of the pump operating, but this one is clicking every two to three seconds whilst idling. I can't find any fuel line leaks that would allow air into the system. is it possible to...
I know, i'm stupid but it was an honest mistake. I accidently put the pos+ on the battery neg- and the neg- on the battery pos+, but it was dark and I was tired. I couldn't figure out why up on the trim was going down and vise versa, and then I realised what I had done. Changed them around the...
I want to install a temperature gauge in my boat and I need to know where the temperature gauge sender goes into the block. I have an OMC temperature gauge and and I also need to know the part number for the sender. It is a 1994 115hp Johnson mod no. BJ115TLERC. Just to confirm, I don't want the...
did omc make a temperature gauge to fit johnson/evinrude outboards. I have a 94 115hp Johnson and the black gauges with white writing and red/orange needles and i would like to get a matching temp gauge if they made one. if not i have an aftermarket one but i would like ome if available
Hey, everybody first post so here i go. I have just installed a Johnson 115hp 1994 on my boat and need to know if there is a steering tension device located on the motor, as it is very stiff to turn, my 90hp that came off the boat was very easy to turn so i know it is not the steering at fault...
