FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
OK....went at this Old School.
Found some Merc wiring color codes and went from there.
Using the test light, the wiring block has two (switched) power feeds, ground, sends for tach, oil level and voltage. I'm guessing this wiring block (pigtail under the helm throttle control) was purpose...
Hey Scott....
Digging indeed. I have no problem doing that; prefer to learn as I go....but help along the way is always nice ;-).
Thanks for your input here.....just want to clarify:
"OR..... an inexpensive set of gauges you want along with their senders...."
Do you mean the senders from the...
Thanks Scott...
I assumed that because the pigtail was there, it was supported.
I imagine many others make the same mistake.
Is there a way to determine by way of the serial#? Or is the lack of the yellow resistor terminal the obvious clue?
If it's not SmartCraft enabled, can it be installed...
Hi everyone,
I just purchased a 2008 Legend V151 Angler with a Mercury 50 HP outboard motor with about 20 hours on it. The boat and motor is in mint condition. The helm has no gauges whatsoever, so I'd like to add a basic gauge package.
Engine serial number is 1B710375.
Contacting dealers in...
