Recent content by tazzerblue5

  1. T

    Timing a 4.3L Vortec engine. No timing marker on TC

    Shop ordered new cover, yes carb engine
  2. T

    Timing a 4.3L Vortec engine. No timing marker on TC

    I had this engine rebuilt, and there is no timing marker on the new TC cover. The crank dampener has marks. How do I dial in TDC?
  3. T

    Quick sliver, throttle control, disassembly to replace trim switch? 1993 Mercruiser.

    I have a trim issue, Up button doesn't work, but trailer button does. down does work. pump is fine. How does this handle come apart?
  4. T

    Mercuriser alpha 1 gen 2 Out drive will not slide in the last 1"

    Ok, so now I'm installing the out drive, mercrusier alpha 1 gen 2. I have the shifter lined up, shift linkage lined up. checked and checked again. I looked at the old drive and if it only has 1inch to go its already in the coupler. What's the Trick? called the dealer and he said to hit with...
  5. T

    Dealer installed, gimble bearing and bellows?

    I'm having the Gimble bearing and bellows replaced in my Alpha 1 gen 2 mercruiser. I had taken the out drive off already. How many hrs. to install? I thought it best being I didn't have the tool to check alignment. Thanks,
  6. T

    engine swap, 4.3 to 5.0?

    Will this bolt right in a 1996 Maxum? I would be replacing the outdrive also. The 4.3 block cracked. Just curious if the hull is made for a direct fit for the engine mounts. Thanks.
  7. T

    Ran out drive without oil.. smoked bearings ect. need replacement. Used.

    Ok Had a Very Bad week, fried converter on camper, then testing boat engine and apparently I didn't put oil back in lower unit.. put muffs on, then ran till I hear some squealing.. NOT GOOD! I'm looking for a used Mercruiser out drive. have a 4.3L with 1.81 ratio. Can I put a unit off a 3.0...
See more
Top