Thanks Chris1956, do you mean something like this?
http://www.totalboat.com/product/polyester-structural-repair-putty/
Would this be the same as using some poly peanut butter mix in the gouge then covering that with csm and the gel coat?
Just kind of seeking confirmation ... I have gouges on the bottom of the boat hull in a few places under the waterline and the first picture shown below is on the keel near the bow (maybe from beaching?). It appears to be deep enough to warrant repairs and looks to be down to but not through the...
Preparing to replace strings, transom, deck, etc as they are completely rotted on my 1978 15' 6" Challenger Mark VI tri hull. I've been reading many rebuild projects on this site and specifically (of course) Friscoboater's rebuild. I've decided to use all polyresin with 1708 and csm, etc.
When...
Looking for some advice ... I have a 1978 15.5 ft Challenger Mark VI tri hull that that I was given. It'll need to be restored (Stingers and what-not). One of the issues with it is basically 60% of the hull below the water line has what I believe to be vary small blistering bubbles and a few...
Hi, If somebody could help me I'd really appreciate it. I'm stumped.
I bought a new to me but used 1975 Johnson 85 HP V4 (85ESL75E) outboard and went to winterize it using muffs. This is my first time using muffs as I've usually tested in a barrel with my smaller motor but this one is too big...
