I want to replace the three split races and bearings and am having a little trouble figuring out what the part # for the races alone are. I have a few retainer and rollers new in the box(387041). It looks like you can buy the races, ring, and rollers and retainer as one(335825) but I don't need...
1991 60deg 175 recirculation check valve replacement
I have one that I want to replace that has a hole in the seal and it leaks. The 1991 schematic isn't to great with id'ing the check valves, and it looks like they say only 3 are required. It looks like the part # is 394884, they say 3 are...
Hello,
I have been wanting to put a 90's smallblock v6 looper in place of a 89 v6 crossflow. I have a friend who has had a 200hr 91 175 that has been sitting for years. I believe my harness will plug right in?? I realize the first couple years of the 150,175 60deg. motors can develop a crack...
A couple months ago I noticed small leak around a couple of the starboard exhaust cover bolts. It drips about 2 drops every 3 seconds idling at the dock, and drips about every second on muffs. The leak hasn't gotten any worse. Should I assume on doing just the outer gasket? Do I need to do...
I have an almost perfect 1979 200 Crank, bearings and ends. My 89' 150 Crossflow's crank splines are completely gone. I know that they say there is a a 76-85 (388306) and 86-91 (396256) but I seem to remember if you have both outside bearings the old crank can be used in the later motors and...
I had a recent multiple failure apparently. *I lost the gears in the lower of my 89 150 Crossflow at the same time that I stripped the driveshaft splines. *I pulled back the throttle before it shot way up and turned the motor off right away to not overheat. Fortunately the crank splines looked...
Hello All,
Here's some info before my question.
The other day I was running my 1989 150 Crossflow and dropped the gears in my lower at about 4000 rpm. I caught the throttle before it shot to the moon and shut it down within a few seconds. It did go well above the normal temp by the guage but...
Hello folks, I have recently bought a old project boat that came with a 1989 150 Crossflow. I have put about a hundred hours on the motor since bringing it back up to snuff with a carb rebuild, l/u reseal, water pump, head gaskets, diverters, stats & poppets. The motor holds between 100 & 105...
