FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Yes I read that post a few times my only concern is where the motor is located…it’s located towards the right back of this engine block and I could burly get my hands in there to remove the black cap. I can’t even stick my head in there to look at what I was doing 😢😢😭😭😭
How do I check the motor? There is no wires coming from the motor. Well at least I don’t think. I was looking. Technically for a motor to work you need power but I don’t see exactly where there at
Ohhh so there is relays in there?!? I took off the 3 Philip head screws but then I saw on top 2 hex screws that went all the way through with nuts on the bottom am like that’s a little over kill to be relays so I didn’t remove the hex screws. I will look into that box today.
Good afternoon all
I have search near and far with no answer.
I have 1979 bay liner liberty. Engine is a Volvo penta 200c out drive is a 280. I don’t no what make. Anyways my tilt won’t go up or down or make any noise at all before it was working. I notice when my son stepped on the out drive...
I need a new sending unit since the gas gage is not reading anything. So my plans are to change it out reguardless and I can look inside tank after replacing sending unit. But I remember looking into tank when I was diagnosing the sending unit it didn’t look to bad
I believe the tank sat for a few years without any fuel in it. It does have a fuel filter port 2 of them actually that we did replace. But I would do whatever to keep gunk going into carb and system
I had a friend rebuild it and he said the jets where full of debris little gunk parts he cleaned it completely all I have to clean is the flame resistor but I haven’t put it back into water just yet was changing spark plugs and I saw that each spark plug was a different gap size
Good morning mates,
Another question before I came to this forum I asked a marineboaring forum I forget what it was called but they said the gap was .025 now so I do what this forum says or what they say that’s a big gap diff in my opinion. Thank you fellow boaters
