Scott06's latest activity

I bought a can doo pro for my old sea doo (2004) just to reset the TPS . I think it was $400 back then and for the home edition You can...

not sure if you need only the upper or as others have said may not be rotten yet...

It will not drip back to the cylinders by pouring It in the hoses. Look at a picture of the elbow part some time the only way it enters...

yes I usually pull the hoses at the thermostat housing lift them up and pour the AF in the hose. Some will leak out the exhaust as the...

you will have that issue with paint as well (oil contamination). Yes a lot of engine builders will bake the block heads and intake so...

Probably depends on what type of powder coating. Both ways are generally considered good corrosion resistance, I jdon't have experience...

epoxy paint it and spray with rhino liner to prevent future corrosion

X2 on this no reason not to do it. The lube bottle and the better water pump are two great reasons to do it

I think it’s a full system, small hose off thermostat housing feed the front of the manifold. This is AF going to manifold , vs hot...

compression and or leakdown test will reveal bad head gaskets

If you are in salt water typical rule of thumb seems to be 5-7 for manifold and riser replacement

The 4.3 and v8 use different exhaust elbows in terms of angle. also if you have a riser they use longer elbows. Yes you can use exhaust...

There are a lot of cheap chit carb kits out there. mikes carb parts is my go to place for mercarbs Kits . might have been the check...

if you had that much crud in the passages, get a ultrasonic cleaner (cheap off amazon etc is fine) and use it to clean the carb- when i...

the accel pump has no affect on the fuel coming out the throttle shaft