Scott06's latest activity

check ball missing or stuck . Depends some have check ball in bottom of well that pump goes into. When pump pushes check ball prevents...

it is unmetered, the throttle shaft is below the boosters and the idle and transition circuits. If you are into classic cars some carbs...

If you fix the flooding from the bowl you won’t see fuel on the throttle shaft. Shaft isn’t letting fuel out its dribbling down the bore...

Float bowl is over full and leaking over. Needle and seat , float not working or too much fuel pressure

Ight be easier to use a short section of braided hose where the nipple is. Mount your sender and switch solidly to engine or bracket...

more flow will give a stronger vacuum signal in boosters/ venturi so would expect more fuel. Yes marine tends to run cooler and under...

4.3. Confirmed with a wide band.

on a 4.3 or larger engine?

Yes and no. I bought a angle torque wrench when I did the timing chain on the mini a couple years back. Found out the POS didnt work...

Here is one https://forums.iboats.com/threads/stumbling-edelbrock-1409-4-3l-v6.670697/page-2

Cant comment on sierra but they are known as a better aftermarket. Most of the time you hear OEM and Barr are the best. I have Barr on...

yes as steel head gaskets will corrode in freshwater (rust). How long it will take ? not sure but doesnt make sense not to change...

you cant really jb weld the internal valley cracks, may also be one in the bottom of the bores/ crank area generally what we have seen...

Jasper seems hit or miss In reviews. truck engine stripped to long block swap head gaskets core plugs (some are brass or stainless...

No any 96 and up 8 bolt intake vortec will work. I did the same project on a 2004 sea ray the 090M block casting 4.3 uses some metric...