Scott Danforth's latest activity

Lou is in cold water. If he was down here in FL, I would say no

Clean the carb and tank Ditch the stabil Then run the motor more often and drain the fuel system after use. Item 15 is the drain...

I just saw an advertisement for an AI spam filter that uses AI. So people are now supposed to pay for AI to police AI.... If that...

Just run a wire from the coil to the choke toaster element

That is concerning. Looks like a cold crack that should not have made it past the coil stage

If you stow it in a garage in Florida, it may last 6 months If you stow it in an air conditioned room, you may get 2 years

Any updates?

A few years back I posted a few flushing nozzles that I made for going in the drain plugs Basically this adapter and a section of 1/4"...

Agreed, need to know the trailer capacity and WET weight of the new boat AT A MINIMUM. Without those two things it's a hard NO. A 14"...

As Bondo stated, there is virtually zero chance of flooding the risers

Ayuh,..... There's little to no chance of that, with a good functioning system,..... If yer that worried 'bout it, after doing so...

Panel bond would be my choice over foam

Get the primary transfer slot set square. Since your 4160 secondary slots are up high, this is just a 2-screw idle mix carb. Get the...

Once you get the slots squared up. You will need a vacuum gauge to set mix. Should be about 3/4-7/8 turn out

Flip the carb over. The secondary screw is underneath. Make sure the transfer slots are both square on the revealed part