Scott Danforth's latest activity

hit the autobody supply store near you. get a pint or quart of tiger hair filler. then fill the voids and give the screw something to...

The list of bad beers that have a lot of advertising to get you to drink the swill is long My favorite beer is a local micro that's in...

Assume 3500-5000 for cost and a fair amount of time

That looks fugly Do you want easy or good? @MikeSchinlaub may have other ideas Easy would be epoxy in a chunk of aluminum in the...

Post #2 answered that question

Then pitch down 2", and control the throttle with your right hand. You will be a tad high lightly loaded and not lugging it moving 9 people

Don't look in the bilge....deny deny deny

My machine shop is still 2k for a complete short block and rebuild to whatever specs you want. 2400 for a long block. I can blow up a...

do you have a heat exchanger, or are you raw water cooled. 1 of 3 things happen when you bury a VP drive in the sand. its light sand...

IT bought us HP printers for the office. POS is being kind to them suckholes of life. T office is 1500 miles away and they wont set...

i hate HP printers and HP in general

And with everyone LS swapping good SBCs and BBCs, many good motors are in the $1k-2k range only needing a cam swap and marine electrics...

Many dealers are struggling right now until you get into the range of boats that are resistant to financial climate changes. even great...

I would try to pull the cap. the cap will have screws and adhesive holding down most of it.

All gel coat oxidizes. There may be a lot of traffic and use scuffs Mike posted the process, just add the elbow grease . Depending on...