Current visitors

Scott Danforth's latest activity

Scott Danforth replied to the thread Tiny boat performance help.

A piece of PVC pipe for a tiller extension Also add trim tabs to extend the running surface

Today at 5:06 AM
Scott Danforth replied to the thread Old 4hp Evinrude takes a nap.

you should have replaced the impeller BEFORE running it.

Yesterday at 8:15 AM
Scott Danforth replied to the thread NEED HELP WITH CHAPARRAL 224 REAR BENCH SLIDING.

remember, with seating, the factory sliding/folding backrest is subjected to the ABYC load and impact test for safety reasons. this is...
Yesterday at 6:31 AM
Scott Danforth replied to the thread I/O (Sterndrive) Conversion to Outboards.

Could always have the admiral help you. Didn't she do bathroom remodeling earlier this year. It's just like mudding drywall

Thursday at 4:08 PM
Scott Danforth replied to the thread Vent Hose Flange Question.

bilge vent hardware was what ever cheap hardware the boat company used that month.

Thursday at 3:18 AM
Scott Danforth replied to the thread 350 MAG MPI Head Bolt spec.

its also on the package the head gasket came in as well as the package the head bolts came in. if the old bolts are TTY (Torque to...

Thursday at 3:17 AM
Scott Danforth replied to the thread 4.3 electrical issues (intermittent is a nasty word!).

wiggle the key when you are testing the switch.

Wednesday at 1:08 PM
Scott Danforth replied to the thread I/O (Sterndrive) Conversion to Outboards.

And go-jo is also goop..... And according to Joe, everything is goop

Wednesday at 2:57 AM
Scott Danforth replied to the thread I/O (Sterndrive) Conversion to Outboards.

Australian and British car guys called it bog starting about 70 years ago .....It's also the term for the toilet or crapper. Because...

Wednesday at 2:55 AM
Scott Danforth replied to the thread I/O (Sterndrive) Conversion to Outboards.

Goop is what you clean your hands with Mud or bog or fairing compound are what you are mixing tomorrow

Tuesday at 5:06 PM
Scott Danforth replied to the thread I/O (Sterndrive) Conversion to Outboards.

just wait until Ted starts to use a wee bit of bog on his extension. (insert homer simpson backing into the shrub GIF here)

Tuesday at 11:07 AM
Scott Danforth replied to the thread Need trailer roller arm mount thing.

what is the trailer manufacturer? have you contacted them? nearly all trailer manufacturers have a parts manual and sell parts

Tuesday at 9:08 AM
Scott Danforth replied to the thread I/O (Sterndrive) Conversion to Outboards.

you could have used a piece of starboard. because short of one specialty solvent based glue, not a thing sticks to starboard.

Tuesday at 7:59 AM
Scott Danforth replied to the thread Advice / Tips for Draining Old gas and checking fuel lines..

I usually pull the fuel sender as @muc suggests. I have a small section of aluminum tube (3/8" fuel line from a hotrod project) on the...

Tuesday at 7:58 AM
Scott Danforth reacted to muc's post in the thread Advice / Tips for Draining Old gas and checking fuel lines. with Like.

The biggest mistake I see when a DIY tries to drain their fuel tank. They try to suck it out with the existing fuel lines. This results...

Tuesday at 7:53 AM