Recent content by sasmit8

  1. S

    12 ft aluminium boat Wood Motor Mount Replacement

    I am replacing the Plywood Motor Mount Pads on a 12ft. Aluminium Boat.I Have the new Pads all cut out. The inner and outer boards are held together with 8 thru-hull bolts. I have 2 questions 1. What should I use to seal out water Silicon? 2. What would the best Bolts to use ...
  2. S

    Carb leaks

    I Have a 1988 suzuki 6 hp (DT6) It starts and runs O.K. but the primer bulb does not get real hard and a steady stream of gas comes out what apears to be a vent hole at the top left of the carburator. The motor has just been started after several years of storage.There is only about 10 hours on...
See more
Top