FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Hi,
Fairly new to outboards, brand new to mercs, have a few questions about this motor i acquired more or less from being thrown out
1) I can't seem to make it trim all the way down?? i'm baffled even with the pin right out??
2) engine starts but there is a tonn of debris/carbon/burned residue...
hi, motor is running good enough i think, i'm more concerned about the spray pattern at the back..doesn't seem quite right. this is a short clip of me 220lb and my mom ~110 lb @ WOT in a 12' aluminum. alone i get 38km/h max speed. now i don't have the tilt pin in, it's been lost, could this...
Hi -- see video at bottom
So I got this motor at the end of last year and it would not idle. Over the winter I've done the impeller+housing, carb kit, replaced the cracked bearing carrier, changed the spark plugs and replaced the slow speed knob. It now idles!
There seems to be some water...
while it's out i figured i'd change my prop seals--
my question is:
are part #'s 7, 2, 4 and 3 INSIDE the bearing carrier already? when i took it off the only loose part was #32
i'm assuming #53 is already mounted in the prop as i didnt see any loose pieces for that either?
also there was no...