FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
engine has always run perfect,took out yesterday started fine,when i got on the gas no power,squeezed the fuel ball a couple of times would run then die,seemed to run if you kept squeezing ball. kicker runs off same tank wheich runs fine but big motor does have a water seperator filter any help...
which direction does the ****er lever usually go when you pull out the pivot pin by mistake when motor is mounted on boat /getting ready to try to realign this weekend thanks for all the advice:confused:
PULLED WRONG SCREW WAS GOING TO DRAIN OIL NOW PIVOT PIN WILL NOT GO IN CAN,T EVEN SEE HOLE TO ALIGN,ANY IDEAS ?GOING TO TRY AND TIP UPSIDE DOWN AS NEXT STEP:facepalm:which direction does the shifer lever usually go when you pull the pin out?
i have a 30hp evinrude i think i have a spun prop when i accelerate,and start to get a load on it it revs up,let off the gas and idle its ok. cant tell by looking at prop bushing seems to look ok not sure.pushing a 12ft sorenson.
