Recent content by rfwj

  1. R

    help re conecting shift linkage to lower unit

    I have a 1997 115 Evinrude and I am trying to re connect the long shift pole to the linkage under the carb. The replacement lower unit is back on and bolted. I know there is a bolt I removed and I can't remember how to get that connected I have a bolt and the pin out. Any advice or photo...
  2. R

    115 1997 evinrude. what size spark plug wires?

    I want to replace my spark plug wires with my plugs. What brand and size should I buy? thanks rich
  3. R

    1997 evinrude high rpm issue slipping (help please)

    Well I thought I had either a trim issue or a prop issue. Basically I run at full and it seems like I am trimmed up too high. Higher pitch to motor like trimmed too high. I also have a odd small rooster tail following now that would not be there if trimmed all the way down. Still my trim is...
  4. R

    115 1996 evinrude runs like it is trimmed up to high?

    I have a 18 ft kencraft with a 96 115 evinrude. the trim appears to go all the way down but the boat runs like it is too trimmed up. I lifted the motor, locked up, and put the tilt trim down. the two trim lifts go all the way down as best as I can tell? Can the middle tilt large lift stop the...
  5. R

    electrical issues just a click anc no trim even

    1997 115 Evinrude. just figured that my power pack was broken. no spark to any plugs and the kill switch was ok. So I replace the power pack. It starts. Yea. But then my battery connection or power to the whole engine seems to be bad somewhere in the engine. It just clicks and then...
  6. R

    97 evinrude no spark to any cylinder

    I just got my motor running well with a carb re build and now no spark to any cylinder. I used a spark checker on all plugs and nothing. No light flash when I turn the motor. I have no idea why this would happen. I have read a kill switch, power pack. It is not a coil since none of them...
  7. R

    1997 evinrude 115 hp E115TSXEU needs carb kit

    I think it is time to rebuild my carbs on my 97 evinrude. Do you all have suggestions on where to buy a kit and what other items I should replace when it have the carbs out. Also a video link would be cool. I have watched the diy stuff for a larger engine. thanks. model number is listed above
Top